OMC Trim Cylinder End Cap

Bad_Influence · **Joined:** April 15th, 2012, 4:18 am **Posts:** 158

Does anyone have the tool that removes the end Cap If so Would like to rent it
I have a 89 Rude 200xp

beavertonae-21 · **Posted:** April 26th, 2012, 7:18 pm

Go to you local marina, they also have a universal tool for those witch work on a few different brands . Usually they will lend it for a day with deposit.cap back out on you?

Steve

Bad_Influence · **Joined:** April 15th, 2012, 4:18 am **Posts:** 158

beavertonae-21 wrote:

Go to you local marina, they also have a universal tool for those witch work on a few different brands . Usually they will lend it for a day with deposit.cap back out on you?

Steve

In Sudbury the city of gouging how about you get me one first telling me the price

beavertonae-21 · **Posted:** April 28th, 2012, 9:22 pm

omc# 912084 $254:63 !!!!! If I had one you could borrow it but I dont. I borrowed one from a local marina when I had my omc. It was a universal two pin adjustable, not as good but it did the job. You could make one out of a piece of aluminum bar stock and three allen screws with a little time and measuring. otherwise do a road trip one day. I would'nt spend that much on something your only using once or twice.

Steve

Bad_Influence · **Joined:** April 15th, 2012, 4:18 am **Posts:** 158

beavertonae-21 wrote:

omc# 912084 $254:63 !!!!! If I had one you could borrow it but I dont. I borrowed one from a local marina when I had my omc. It was a universal two pin adjustable, not as good but it did the job. You could make one out of a piece of aluminum bar stock and three allen screws with a little time and measuring. otherwise do a road trip one day. I would'nt spend that much on something your only using once or twice.

Steve

Im starting to make one ,thanks for the info

HPBCANADA.COM

OMC Trim Cylinder End Cap

Who is online