| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| OMC Trim Cylinder End Cap http://ww.w.hpbc.ca/viewtopic.php?f=19&t=125 |
Page 1 of 1 |
| Author: | Bad_Influence [ April 20th, 2012, 3:07 pm ] |
| Post subject: | OMC Trim Cylinder End Cap |
Does anyone have the tool that removes the end Cap If so Would like to rent it I have a 89 Rude 200xp |
|
| Author: | beavertonae-21 [ April 26th, 2012, 7:18 pm ] |
| Post subject: | Re: OMC Trim Cylinder End Cap |
Go to you local marina, they also have a universal tool for those witch work on a few different brands . Usually they will lend it for a day with deposit.cap back out on you? Steve |
|
| Author: | Bad_Influence [ April 27th, 2012, 9:08 am ] |
| Post subject: | Re: OMC Trim Cylinder End Cap |
beavertonae-21 wrote: Go to you local marina, they also have a universal tool for those witch work on a few different brands . Usually they will lend it for a day with deposit.cap back out on you? Steve In Sudbury the city of gouging  how about you get me one first telling me the price
|
|
| Author: | beavertonae-21 [ April 28th, 2012, 9:22 pm ] |
| Post subject: | Re: OMC Trim Cylinder End Cap |
omc# 912084 $254:63 !!!!! If I had one you could borrow it but I dont. I borrowed one from a local marina when I had my omc. It was a universal two pin adjustable, not as good but it did the job. You could make one out of a piece of aluminum bar stock and three allen screws with a little time and measuring. otherwise do a road trip one day. I would'nt spend that much on something your only using once or twice. Steve |
|
| Author: | Bad_Influence [ April 29th, 2012, 9:36 pm ] |
| Post subject: | Re: OMC Trim Cylinder End Cap |
beavertonae-21 wrote: omc# 912084 $254:63 !!!!! If I had one you could borrow it but I dont. I borrowed one from a local marina when I had my omc. It was a universal two pin adjustable, not as good but it did the job. You could make one out of a piece of aluminum bar stock and three allen screws with a little time and measuring. otherwise do a road trip one day. I would'nt spend that much on something your only using once or twice. Steve Im starting to make one ,thanks for the info |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |