| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| transferring internals of a lower unit http://ww.w.hpbc.ca/viewtopic.php?f=19&t=2172 |
Page 1 of 1 |
| Author: | wottz [ May 5th, 2014, 10:47 am ] |
| Post subject: | transferring internals of a lower unit |
hi all i have a titus lower unit and it was made from a stock merc lower. i currently have a stock merc 200 promax lower on the motor and want to put the internals from the stock lower into the titus low water lower. other then a merc dealer, does anyone know of someone who will do this in the Manitoba area? or should i just go and get it done at a shop? If the titus lower is made from a stock merc lower, will it still have to be shimmed different then the stock lower? thanks for the replies |
|
| Author: | DoktorC [ May 5th, 2014, 11:59 am ] |
| Post subject: | Re: transferring internals of a lower unit |
Usually you have to shim to match the case to account for any machining differences. Any merc dealer should be able to handle the job or if you've got a good shop in your area that does a lot of lowers... |
|
| Author: | AnthonySS [ May 5th, 2014, 4:56 pm ] |
| Post subject: | Re: transferring internals of a lower unit |
Consider shipping it to to Dave Pally at Pally's Performance in Saskatoon...or even drive it there. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |