| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| Re-Hub a Prop http://ww.w.hpbc.ca/viewtopic.php?f=19&t=230 |
Page 1 of 1 |
| Author: | Bad_Influence [ May 16th, 2012, 4:05 pm ] |
| Post subject: | Re-Hub a Prop |
Where can I sent to re-hub a Mazco RE4 Prop ? |
|
| Author: | DoktorC [ May 16th, 2012, 4:27 pm ] |
| Post subject: | Re: Re-Hub a Prop |
Kawartha Prop Repair.. http://www.buckhornyachtharbour.com/prop.php |
|
| Author: | beavertonae-21 [ May 16th, 2012, 7:19 pm ] |
| Post subject: | Re: Re-Hub a Prop |
a 1" hole saw and cordless drill attached to a fairly steady redneck taking about 1" of the spline material from the backside will alow you to run the prop on the omc. my Beaverton redneck 2 cents.... |
|
| Author: | Bad_Influence [ May 16th, 2012, 8:28 pm ] |
| Post subject: | Re: Re-Hub a Prop |
beavertonae-21 wrote: a 1" hole saw and cordless drill attached to a fairly steady redneck taking about 1" of the spline material from the backside will alow you to run the prop on the omc. my Beaverton redneck 2 cents.... Thats not the problem.... I purchased the prop......not looking at the splines and 95 % of the splines are worn out they are paper thin |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |