| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| valero first run. http://ww.w.hpbc.ca/viewtopic.php?f=19&t=2305 |
Page 1 of 5 |
| Author: | BoomerMuskoka [ July 5th, 2014, 7:15 pm ] |
| Post subject: | valero first run. |
took the valero too the lake today , new lwp case is on  , i'm about even with the pad, 28 mazco cleaver and i RAN 79.7 full of fuel plus 3 jerrry cans and my gf  im going too try a chopper tomorrow and see how it runs, lake was rough today not much space too open it up  try again tomorrow 
|
|
| Author: | BoomerMuskoka [ July 5th, 2014, 7:18 pm ] |
| Post subject: | Re: valero first run. |
it almost seems like its cutting out again at 79 , but i still have water pressure im going to have too drive it some more before ill know whats going on 
|
|
| Author: | idvette [ July 5th, 2014, 7:49 pm ] |
| Post subject: | Re: valero first run. |
Man I shoulda texted you, was in port sydney at the beach today, was thinking I'd rather be boatin lol |
|
| Author: | 1 I Bandit [ July 6th, 2014, 7:12 am ] |
| Post subject: | Re: valero first run. |
Glad to hear you got the Valero out, it was a little windy yesterday for runnin what pitch chopper? idvette and Boomer you can always stop by here and do both beach and boat 
|
|
| Author: | DoktorC [ July 6th, 2014, 9:49 am ] |
| Post subject: | Re: valero first run. |
Good to hear you're out Boomer. How high is it revving?? Is the cut out a miss or a full blown stoppage/surge? |
|
| Author: | BoomerMuskoka [ July 6th, 2014, 11:11 pm ] |
| Post subject: | Re: valero first run. |
DoktorC wrote: Good to hear you're out Boomer. How high is it revving?? Is the cut out a miss or a full blown stoppage/surge? had it out again today this time with a 28p chopper moved the motor up. Dok 5600 is all i can get out of it then it starts too stumble so i let out,,my 15 psi  water pressure guage is pegged so im getting water now and 80 today my thoughts were its starving for fuel or oil bottle isnt keeping up or rev limiter i still have it hooked up could that be it
|
|
| Author: | BoomerMuskoka [ July 6th, 2014, 11:19 pm ] |
| Post subject: | Re: valero first run. |
1 I Bandit wrote: Glad to hear you got the Valero out, it was a little windy yesterday for runnin what pitch chopper? idvette and Boomer you can always stop by here and do both beach and boat i was running a 28 today, almost went too skeleton today but ended up going too a couple smaller lakes. |
|
| Author: | dubber [ July 6th, 2014, 11:56 pm ] |
| Post subject: | Re: valero first run. |
Just to be sure check your fuel filter. I had a similar problem except it wouldn't rev beyond 5k. The filter had a piece of carpet in it restricting flow. It ran fine after removing it. Don't ask how it had carpet in it... |
|
| Author: | OneCycle [ July 7th, 2014, 7:16 am ] |
| Post subject: | Re: valero first run. |
Maybe a TPS Adjustment is required. |
|
| Author: | BoomerMuskoka [ July 7th, 2014, 8:29 am ] |
| Post subject: | Re: valero first run. |
OneCycle wrote: Maybe a TPS Adjustment is required. how do a test it :s that makes sense because it only cuts out at wot, im going to pull the tank and make sure everything is clean also.. |
|
| Page 1 of 5 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |