| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| OMC Triple 56ci torque settings http://ww.w.hpbc.ca/viewtopic.php?f=19&t=2415 |
Page 1 of 1 |
| Author: | AUS racer [ August 21st, 2014, 8:42 am ] |
| Post subject: | OMC Triple 56ci torque settings |
As the title says does anybody know the torque settings for the OMC triple [70hp] 56ci engines, rod caps, head casing ect. I'm building an engine and don't have the specs. Any other things I should look out for while building the motor? |
|
| Author: | Hevi Kevi [ August 21st, 2014, 11:39 am ] |
| Post subject: | Re: OMC Triple 56ci torque settings |
head bolts 20 ft lbs rod bolts 30 ft lbs flywheel nut 100 ft lbs I have an old Seloc Manual for L3, V4, V6 OMCs here I've had for about 15 years or more. Comes in handy from time to time. |
|
| Author: | AUS racer [ August 22nd, 2014, 8:25 am ] |
| Post subject: | Re: OMC Triple 56ci torque settings |
Great thanks for that its a great help. Next question those motors have a 7 pin plug and socket for plugging the motor to the loom. I hacked away at the wiring and was unable to take not of what cable was what. Does anybody know what each cable does? |
|
| Author: | phillnjack [ September 16th, 2015, 3:53 pm ] |
| Post subject: | Re: OMC Triple 56ci torque settings |
be careful as the seloc manuals are total rubbish, far too many things wrong in those scrap books. best to check with a genuine manual for torque specs. and not all triples have the same spec. there are different cranks different heads and even different blocks and all have different toque settings. some of us don't even have to undo the head to change a thermostat on a triple !!! aus racer has a totally different block to you reg. his block is the oval port. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |