HPBCANADA.COM
http://ww.w.hpbc.ca/

Easy SST60 gearbox
http://ww.w.hpbc.ca/viewtopic.php?f=19&t=2526
Page 1 of 1

Author:  AUS racer [ October 14th, 2014, 6:29 am ]
Post subject:  Easy SST60 gearbox

Has anybody got an easy solution to getting the same or similar gearbox ratio as the sst60/stinger 15inch [15:28] from a standard nitro gearbox [12:29] is there any reason I couldn't get a 15 tooth pinion gear made up and run it on the 29 tooth gears? anyone tried this before? seems a lot easier and cheaper than spending $1700 on a seaway genuine box?

Author:  Hevi Kevi [ October 14th, 2014, 4:35 pm ]
Post subject:  Re: Easy SST60 gearbox

will have to make a custom driveshaft out of a 2 cylinder and a 3 cylinder and graft them together. Different water pump on the 3 cyl, some forward bearing carriers on the 2 cylinder are the same, others aren't, and then buy some gears from seaway. Maybe they have new driveshafts too? Don't know.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com