| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| Solid mounts v rubber mounts ? http://ww.w.hpbc.ca/viewtopic.php?f=19&t=3096 |
Page 1 of 1 |
| Author: | phillnjack [ October 1st, 2015, 7:02 pm ] |
| Post subject: | Solid mounts v rubber mounts ? |
Hi guys I know many of you on here have some very serious fast boats, and for these I understand you need to have very precise steering. But for us mere mortals who only ever dream of having a boat that goes over 60mph what would be the best mounts when having to change a set. ? I don't even know what material the solids are made from i.e alloy stainless steel, iron etc. Also from what I understand if the tops are solid then the bottoms also need to be solid ? opinions on mounts would be good. . |
|
| Author: | DoktorC [ October 1st, 2015, 10:06 pm ] |
| Post subject: | Re: Solid mounts v rubber mounts ? |
If you can drive your boat without solid mounts than don't bother...not worth the rattles IMO. |
|
| Author: | phillnjack [ October 2nd, 2015, 8:32 am ] |
| Post subject: | Re: Solid mounts v rubber mounts ? |
I will take that as a no no for just cruising around. I am no way the owner of a race boat and already have a few rattles in my tug. I suppose if originals have lasted 20 years they cant be too bad. Thanks for swift reply. In a way it was answer i was looking for. Phill. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |