HPBCANADA.COM
http://ww.w.hpbc.ca/

URGENT!!
http://ww.w.hpbc.ca/viewtopic.php?f=19&t=373
Page 1 of 1

Author:  Bad_Influence [ July 3rd, 2012, 12:32 pm ]
Post subject:  URGENT!!

Can this 1989 Land-N-Sea Jack Lift support a 525 Lb 250 hp Outboard

Author:  DoktorC [ July 3rd, 2012, 1:15 pm ]
Post subject:  Re: URGENT!!

Which lift is it???

Author:  beavertonae-21 [ July 3rd, 2012, 1:39 pm ]
Post subject:  Re: URGENT!!

I think it's the late 80'2 early 90's with the omc trim pump.

Steve

Author:  Bad_Influence [ July 3rd, 2012, 2:18 pm ]
Post subject:  Re: URGENT!!

DoktorC wrote:
Which lift is it???


1989 omc pump

Author:  DoktorC [ July 3rd, 2012, 2:25 pm ]
Post subject:  Re: URGENT!!

It may struggle with a 3.3L on it....

Author:  Bad_Influence [ July 3rd, 2012, 2:51 pm ]
Post subject:  Re: URGENT!!

DoktorC wrote:
It may struggle with a 3.3L on it....


Struggle lifting it or struggle just driving it without the lift?

Author:  beavertonae-21 [ July 3rd, 2012, 3:27 pm ]
Post subject:  Re: URGENT!!

that plate was not designed for the big motas! try Paul at top gun or John Spaeth and see if you can pickup a used one. did you get a chance to look at the big Yammi yet?

Author:  Northbase [ July 3rd, 2012, 3:35 pm ]
Post subject:  Re: URGENT!!

I wouldn't try it.
I had one of those lifts back in the 80's and I recall something about them being rated for (back then) v-6 use only (not v-8's). I think the jist of the warning was that they were designed for a 2.4/2.5/2.6 v-6 and not the monster 3.4 v-6 or 3.6/4.0 v-8.
Just my .02$
Cheers

Author:  DoktorC [ July 3rd, 2012, 3:36 pm ]
Post subject:  Re: URGENT!!

The lift will struggle...the boat will rock with a 250 HPDI...

Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com