HPBCANADA.COM
http://ww.w.hpbc.ca/

T850 - Making long shaft to short shaft
http://ww.w.hpbc.ca/viewtopic.php?f=19&t=725		 Page 1 of 1
Author:  Hevi Kevi [ November 7th, 2012, 12:29 pm ]
Post subject:  T850 - Making long shaft to short shaft
I've been messing around in the shop trying to find a way to make my long shaft 70 into a short shaft while using the original power trim unit. Lots of cutting, welding and making custom pieces but it looks like it will work as long as I don't go down to the last 1/2 inch of travel down on the trim or it will bind for steering. I will likely set up stops so it can't go down all the way. It still leaves lots for travel. I made solid mounts for the bottom which will be 1 piece next time instead of the mount with a spacer. I just didn't have the material I needed and wanted to get it done that night. Will I be allowed to run this? I just want to use what I have around the shop and keep costs down.

Attachments:
North Perth-20121030-00359.jpg
North Perth-20121030-00359.jpg [ 125.08 KiB | Viewed 1413 times ]
IMG-20121029-00356.jpg
IMG-20121029-00356.jpg [ 177.27 KiB | Viewed 1413 times ]
North Perth-20121106-00398.jpg
North Perth-20121106-00398.jpg [ 135.27 KiB | Viewed 1413 times ]
Author:  WalkWithMax [ November 7th, 2012, 1:23 pm ]
Post subject:  Re: T850 - Making long shaft to short shaft
That looks cool!! Lots of engineering for sure! Tell us more about your boat and motor setup...
Dave.
Author:  Hevi Kevi [ November 7th, 2012, 2:44 pm ]
Post subject:  Re: T850 - Making long shaft to short shaft
Thank you. I just bought Chris Gordon's Rapid craft and I'm planning to run that next season with a 56ci omc once I modify the cell. I have the 56 engine and will be working on it over the winter. I'm still in need of a nitro gearcase or preferably an SST-60 gearcase. Even a set of gears will work for me. I'm gonna need a couple props too.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com