On our way back from sudbury, got a little something following us back. http://ontario.kijiji.ca/c-ViewAdLargeI ... =516653021
It's pretty clean, appears to be a true bridgeport. Gonna be sweet
| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| New motor http://ww.w.hpbc.ca/viewtopic.php?f=2&t=1702 |
Page 1 of 1 |
| Author: | 13Checkmate [ October 11th, 2013, 11:39 am ] |
| Post subject: | New motor |
On our way back from sudbury, got a little something following us back. http://ontario.kijiji.ca/c-ViewAdLargeI ... =516653021 It's pretty clean, appears to be a true bridgeport. Gonna be sweet
|
|
| Author: | tunnelv [ October 11th, 2013, 12:11 pm ] |
| Post subject: | Re: New motor |
saw that on Kijiji before, did it come with a lower unit? should sound sweet with that mid! looks like a 2 piece adapter plate with is non Bridgeport i think |
|
| Author: | 13Checkmate [ October 11th, 2013, 12:16 pm ] |
| Post subject: | Re: New motor |
Came with a lower and got it for less. The power head does appear to be a Bridgeport, took a little look and it looks right. The cowl is pretty much mint and weights almost nothing. |
|
| Author: | tunnelv [ October 11th, 2013, 12:36 pm ] |
| Post subject: | Re: New motor |
Cool ya i agree about the rest just the adapter may not be true BP, what you putting it on? |
|
| Author: | 13Checkmate [ October 11th, 2013, 12:48 pm ] |
| Post subject: | Re: New motor |
Gonna be going onto my Valero project whenever I get that done. Looking to do the rebuild myself if the damage isn't too bad. |
|
| Author: | 13Checkmate [ October 11th, 2013, 8:51 pm ] |
| Post subject: | Re: New motor |
Its definitely a bridgeport, pulled the heads and its proper. It appears that it caught a ring on #4 and chunked the port of the sleeve. So ill need a head, sleeve and a piston, other then that the motor seems pretty solid. No grinding from bad bearings in the bottom end, the other bank of cylinders look pretty dam good. Looks like its lived a few lives though, sleeves down the port side not sure about the starboard, when it looked fine i didnt look any farther. |
|
| Author: | 13Checkmate [ October 14th, 2013, 6:48 pm ] |
| Post subject: | Re: New motor |
Got some pictures to put up tonight. The piston that let go looks like the rings caught an intake and an exhaust port, chunked the sleeve and part of the block. Question is can this be fixed by re-sleeving or welding then machining to proper size or is the block toast? |
|
| Author: | 13Checkmate [ October 14th, 2013, 10:12 pm ] |
| Post subject: | Re: New motor |
     kinda hard to see the port damage because of the angle, it took quite the chunk out from the looks of it. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |