| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| DIY Reed valves? http://ww.w.hpbc.ca/viewtopic.php?f=2&t=2445 |
Page 1 of 1 |
| Author: | AUS racer [ September 4th, 2014, 8:25 pm ] |
| Post subject: | DIY Reed valves? |
Has anybody had any experience with diy carbon fibre reed valves? buying a sheet of carbon fibre and cutting out your own? I was thinking of buying some of these sheets and cutting them out. http://www.ebay.com.au/itm/360936775267 ... 1423.l2649 Yes I have tried to buy them [from chris carson marine] with no luck so don't make that suggestion. |
|
| Author: | DoktorC [ September 5th, 2014, 8:59 pm ] |
| Post subject: | Re: DIY Reed valves? |
I've dealt with Tony Doukas with good results. If you want to give buying reeds another shot... http://www.bansheedepot.com/categories.asp?cat=29 Tony talked to me for a long time to fully determine my needs...and actually recommended against carbon. It did take a couple of calls but it was worth it. |
|
| Author: | AUS racer [ September 5th, 2014, 9:09 pm ] |
| Post subject: | Re: DIY Reed valves? |
DoktorC wrote: I've dealt with Tony Doukas with good results. If you want to give buying reeds another shot... http://www.bansheedepot.com/categories.asp?cat=29 Tony talked to me for a long time to fully determine my needs...and actually recommended against carbon. It did take a couple of calls but it was worth it. Not calling from Australia that's going to cost more than the reeds will, and the website does not list anything for OMC. |
|
| Author: | DoktorC [ September 5th, 2014, 9:23 pm ] |
| Post subject: | Re: DIY Reed valves? |
Ooook.. Boyenen has a distributor in Australia. Saves the long distance charges. |
|
| Author: | AUS racer [ September 5th, 2014, 10:43 pm ] |
| Post subject: | Re: DIY Reed valves? |
Yeah I found the boyesen distributor in AUS but I don't think they deal with outboards. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |