| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| Sometimes the Remote Control Boat Guys have an idea! http://ww.w.hpbc.ca/viewtopic.php?f=20&t=4500 |
Page 1 of 1 |
| Author: | Hounddog [ December 2nd, 2023, 7:50 pm ] |
| Post subject: | Sometimes the Remote Control Boat Guys have an idea! |
Adding setback on a performance tunnel hull is common. The weight of the outboard changes the boat balance especially with the motor trimmed out and wind or a wave cause the bow to lift. What if you moved the engine position to inside the boat and ran a drive shaft from it thru the bottom of the tunnel and thru the gearcase of the outboard. You could run a larger engine. The weight of the engine being in the front portion of the boat should improve the boat balance. Being a tunnel the driveshaft will likely be above the water with the boat at speed. The idea of having a long drive shaft extended out the transom was successfully done on large offshore style hulls. I have not seen this idea on a tunnel. https://www.youtube.com/watch?v=rDHuXEnDXnM |
|
| Author: | Hounddog [ December 4th, 2023, 3:23 pm ] |
| Post subject: | Re: Sometimes the Remote Control Boat Guys have an idea! |
I thought I would get a reply with the question. How could you steer the boat with a driveshaft thru the gearcase? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |