I am going to donate a set of my adjustable setbacks (I don't call them jackplates because you can't adjust them with the motor on) for the T group. I think Paul is the class rep so up to him what he wants to do with it. Raffle it off or give it out for a prize. It will be the same as the one pictured in blue here. I had 2 sets anodized like that. One will go on my Critch. It is about a 3" setback and it has 1" of adjustment up or down to fine tune it between your motor hole positions. The slots all have custom SS oval washers to help avoid the slots from getting marred up with the bolts are tightened. The center is opened up to keep it light weight and allow room for through transom trim. If you are using an OMC with the sloppy clamp brackets, there is extra tapped holes to run bolts through the swivel bracket on the motor to keep it tight against the plate. I think it's a must for the OMCs! It also has an angle built in for more neg trim. I haven't figured out what I'm going give the Stock Outboard guys yet but I'll figure out something that can be useful to them too.
