HPBCANADA.COM
http://ww.w.hpbc.ca/

Build your own Dual purpose T Boat...14 foot molds..
http://ww.w.hpbc.ca/viewtopic.php?f=26&t=1841		 Page 1 of 1
Author:  Hounddog [ December 11th, 2013, 10:47 am ]
Post subject:  Build your own Dual purpose T Boat...14 foot molds..
http://ontario.kijiji.ca/c-cars-vehicle ... Z293810594

If these molds are good. Here is the opportunity for a group of interested WHAT TO BUILD THEIR OWN BOAT GUYS.
Jakes old Checkmate with a long shaft 70 hp was competitive in T750. I am sure the T750 current racers would welcome you if you were running this hull with similar power.
Author:  BoomerMuskoka [ December 11th, 2013, 11:10 am ]
Post subject:  Re: Build your own Dual purpose T Boat...14 foot molds..
is that a checkmate or a 14' sidewinder? That would be a really cool project to pop a few hulls . :D
Author:  Blizz [ December 11th, 2013, 11:19 am ]
Post subject:  Re: Build your own Dual purpose T Boat...14 foot molds..
It's a set of Sidewinder or clones, probably either fiberform or fibertron.
Author:  Hounddog [ December 11th, 2013, 11:24 am ]
Post subject:  Re: Build your own Dual purpose T Boat...14 foot molds..
I am sure these molds were for sale a few times. This time the owner is open for offers. The hull looks similar to a 14 for Sidewinder. There was a group on 6 Mile Lake that were looking to build Deltas, but, their mold was not good enough. This hull with a 70 hp should be a 50 to 55 mph boat. It would run similar to the 14 foot Checkmates and be a good dual purpose boat.
Author:  Hounddog [ December 11th, 2013, 12:49 pm ]
Post subject:  Re: Build your own Dual purpose T Boat...14 foot molds..
Who would be interested in being part of the boat building MEMBERS group?
We first need a location to store the molds and build the boats.
As a build member you help build a boat for each INITIAL member of the group.
The cost is split equally amount the initial members.
Your must race the boat at least TWICE.
After you build the intial members boats and your own boat. you can sell your membership to another person .

COMMENTS-INTEREST?
Author:  BoomerMuskoka [ December 11th, 2013, 3:58 pm ]
Post subject:  Re: Build your own Dual purpose T Boat...14 foot molds..
Hounddog wrote:
Who would be interested in being part of the boat building MEMBERS group?
We first need a location to store the molds and build the boats.
As a build member you help build a boat for each INITIAL member of the group.
The cost is split equally amount the initial members.
Your must race the boat at least TWICE.
After you build the intial members boats and your own boat. you can sell your membership to another person .

COMMENTS-INTEREST?


i could go in on that. :D who else in interested, and can we make some changes to the mold to make it unique, like a pad mod or some thing neat like a stepped pad , :D
Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com