| HPBCANADA.COM http://ww.w.hpbc.ca/ |
|
| T750 - Johnson 60hp 2 cylinder short shaft http://ww.w.hpbc.ca/viewtopic.php?f=27&t=1360 |
Page 1 of 1 |
| Author: | Hevi Kevi [ June 25th, 2013, 9:01 pm ] | |||
| Post subject: | T750 - Johnson 60hp 2 cylinder short shaft | |||
As the title says, Johnson 60hp short shaft for sale. 150psi both cylinders and it doesn't look like the block has been split before. Number on block says 328100. Nice shape $1100
|
||||
| Author: | Hounddog [ June 25th, 2013, 10:39 pm ] |
| Post subject: | Re: T750 - Johnson 60hp 2 cylinder short shaft |
This is the same motor the top T750 guys are running. It has the primer carbs, nitro case and it is the preferred 100 block. You can get factory trim for this motor. Both the early side ram and later model inside ram models fit. Old motors need to be taken apart and inspected. These are not costly to rebuild if it is done before they blow up. Only weak part on this model is the crank. If the motor is rebuilt fresh, they last and they make good power. |
|
| Author: | LittleCharger [ June 26th, 2013, 7:41 am ] |
| Post subject: | Re: T750 - Johnson 60hp 2 cylinder short shaft |
One of the other advantages of the OMC two banger is they take the same props as the 49er and 56er in terms of spline, diameter and pitch so if you upgrade to T850 you don"t have to look for new props, the OMC props are a little more plentiful and can be borrowed from other drivers to test and run. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| © 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com | |