HPBCANADA.COM
http://ww.w.hpbc.ca/

2.5 200 Exhaust Divider, Flywheel, and Ignition Parts
http://ww.w.hpbc.ca/viewtopic.php?f=28&t=3346		 Page 1 of 1
Author:  mwe14 [ May 3rd, 2016, 11:06 am ]
Post subject:  2.5 200 Exhaust Divider, Flywheel, and Ignition Parts
Selling some parts off of a 2.5 200 carb engine. Took them off my engine when I switched it to LH rotation a while ago and they have been sitting in the shop in my way ever since. Need to clear some space.

-Plastic fly wheel cover.
-RH Flywheel and stator (40amp)
-RH starter motor
-Exhaust divider for larger water cooled voltage regulator. Comes with a water block off plate I made to run a different voltage reg.
-40 amp water cooled voltage regulator
-smaller voltage regulator that I was going to run with 16 amp charging system but didn't end up using.
-Coil mounting plate
-Trim solenoids
-Electric choke/primer

I know I should post prices with these, but I'm not sure how much to ask for everything, if any of you know reasonable prices for these parts please let me know, or make reasonable offers.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
© 2000, 2002, 2005, 2007 phpBB Group • http://www.phpbb.com