Martini 26 build

Dougw · **Posted:** May 14th, 2014, 7:17 am

dubber wrote:

Use a different decal set for the other motor that implies a different HP rating. You will blow people's minds that you are not doing circles while under power LOL!

Looking real good

ya like mouting a yamaha beside a merc and watching the yammie trying to keep up....sorry couldn't resist.

looks good.

BoomerMuskoka · **Posted:** May 14th, 2014, 7:40 am

Isabella_Steamroller wrote:

Its definetly for real now.... I was starting to panick about the money i had into it. But
Now i can see it

shes gonna be a keeper thats for sure.. i like this project ... alot.

OneCycle · **Posted:** May 14th, 2014, 7:14 pm

this photo is at 1 3/4 below the back of the boat... and thats where the porta is neutral... so i think we're close... i hope

Seastar 2cylinder set up with connecting tie bar.

Dougw · **Posted:** May 14th, 2014, 10:22 pm

Looking good.

btw..Watch the 90 degree fittings on the front of the Seastar rams don't hit the top of your setback bracket when trimming up the motors......been there done that. Snaps them right off.

Isabella_Steamroller · **Joined:** February 14th, 2013, 7:04 pm **Posts:** 234

Dougw wrote:

Looking good.

btw..Watch the 90 degree fittings on the front of the Seastar rams don't hit the top of your setback bracket when trimming up the motors......been there done that. Snaps them right off.

Ordered 2 bobs machine 6" fixed setbacks. Should be here by tuesday... Should eliminate thAt problem.... Im more worried about not trimming both motors at identical times and snapping or ruining the tiebar lol.

Dougw · **Posted:** May 15th, 2014, 7:10 am

Isabella_Steamroller wrote:

Dougw wrote:

Looking good.

btw..Watch the 90 degree fittings on the front of the Seastar rams don't hit the top of your setback bracket when trimming up the motors......been there done that. Snaps them right off.

Im more worried about not trimming both motors at identical times and snapping or ruining the tiebar lol.

To overcome that issue I used to have 3 trim buttons. I had both motors spliced to 1 button that trimmed both motors at the same time and then the individual trim buttons could fine tune the trim position for each individual engine.

KAL Racing · **Joined:** April 8th, 2012, 8:11 am **Posts:** 1297

After watching that boat run in the big water with the single XB , I said too myself, Wow that looks like a lot of Fun 8-)

… Now that bitch is going too be Twice the Fun 8-)

… Looks soooo Sweet with the Twin's on her :mrgreen:

… Nice job Guy'z

Isabella_Steamroller wrote:

OneCycle · **Posted:** May 15th, 2014, 9:01 am

if its controllable it will be fast. it will prob be done in the next couple weeks... Kevins Waiting on some Dana Marine stuff, merc harness and gauges. we're hoping to get everything up in till those parts done this week.

Isabella_Steamroller · **Joined:** February 14th, 2013, 7:04 pm **Posts:** 234

What countless hours of polishing gets you

DoktorC · **Posted:** May 20th, 2014, 5:14 pm

Isabella_Steamroller wrote:

What countless hours of polishing gets you

That..is AWESOME. One thing I always love about boats from that era is the quality of hardware they used. They truely don't build shit like that anymore.

HPBCANADA.COM

Martini 26 build

Who is online